Battery (Ignition)
With your Jetsurf you would have received a battery charger. This is very important, this battery charger has been partially designed for the Jetsurf. You cannot use any other charger to recharge your battery. Before recharging your battery there are a few things you need to know. There is to types of settings to recharge your battery, the first is for the car charger, which can be plugged into any car cigarette lighter unit and the second one is for the home socket. 1st I am going to explain you the settings that you will need to put your battery charger to. The 1st thing you will need to select is battery type. So I am going to push the battery type button until I get to LIFE. Then I will press ENTER. Next I will need to select how many amps I want to be charging at. For a power point as in your typical house you are going to want to have it at 4A. So I am going to press the incline button and then I am going to select how many cells my battery is. This is a 3-Cell battery, so you will always set the cells to 3-Cells. If I am going to be charging from my car power point, I will most likely put it at a 2A charge. I will go to 4A and I will press the decline button until it goes down to 2A. Right now I am going to show you how to connect you battery charger to your Jetsurf. Right now I am charging from the wall charger at home. So I have selected a 4A battery charge. So I am going to to disconnect my battery seal from my battery, then I press the button down and I pull the battery seal apart. It is very important to make sure you put this back together once you have finished charging. So now I am going to connect my charger into my battery. Now to start charging I will hold the ENTER button down for around 2 seconds.
It should come up with a message “Battery Check….. Now my battery has started charging. Generally a battery will take around 45min to charge fully from flat. My charger will automatically start beeping as soon as my battery is fully charged. A fully charged battery should show between 10.7 and 10.8 volts.
It should come up with a message “Battery Check….. Now my battery has started charging. Generally a battery will take around 45min to charge fully from flat. My charger will automatically start beeping as soon as my battery is fully charged. A fully charged battery should show between 10.7 and 10.8 volts.
